Crystal CS423x サウンドチップを設定し、その DSP 機能を有効にするには、 以下の順序でモジュールをロードします。 modprobe sound insmod ad1848 insmod uart401 insmod cs4232 io=* irq=* dma=* dma2=* パラメータの意味は次の通りです。 io--Windows サウンドシステム の I/O アドレス (通常は 0x534) irq--このデバイスの IRQ dma and dma2--DMA チャネル (DMA2 はおそらく 0) カードの中には PnP でない設定をしようとして失敗するものがあります。 もし問題があったら Linux の PnP 機能を使います。 MIDI 機能を使うには次のようにします。 insmod opl3 io=* "io" は OPL3 シンセサイザ の I/O アドレスです。 これは /proc/sys/pnp にあり、通常は 0x388 です。 日本語訳:林(hayashi@net.email.ne.jp) 1999.5.6 -------------------------- To configure the Crystal CS423x sound chip and activate its DSP functions, modules may be loaded in this order: modprobe sound insmod ad1848 insmod uart401 insmod cs4232 io=* irq=* dma=* dma2=* This is the meaning of the parameters: io--I/O address of the Windows Sound System (normally 0x534) irq--IRQ of this device dma and dma2--DMA channels (DMA2 may be 0) On some cards, the board attempts to do non-PnP setup, and fails. If you have problems, use Linux' PnP facilities. To get MIDI facilities add insmod opl3 io=* where "io" is the I/O address of the OPL3 synthesizer. This will be shown in /proc/sys/pnp and is normally 0x388.